MIPS Error Messages C2526 - C2610 (Windows Embedded CE 6.0)

2012-01-05

1/5/2010

The following table shows MIPS error messages number 526 through 610.

No.	Severity	Message text
C2526	ERROR	Code can only be placed in text
C2527	ERROR	Bad instruction opcode
C2528	INFO	Preparing gp-tables
C2529	INFO	Building gp-tables
C2530	ERROR	Label referenced but not defined: %s
C2531	ERROR	Not all branch-label symbols were defined
C2532	ERROR	C0 opcode must be inside .set noreorder section
C2533	ERROR	Byte address of jump target must fit in 28 bits
C2534	ERROR	Jump target is not word-aligned
C2536	ERROR	Register must differ from base
C2537	ERROR	Operand 1 should be fp reg
C2538	ERROR	ulwu instruction not implemented
C2539	ERROR	coproc doubles not implemented
C2540	ERROR	li.e instruction not implemented
C2542	ERROR	Exponent out of range: %s
C2543	ERROR	Only \\""1\\"" or \\""0\\"" allowed left of binary point: %s
C2544	ERROR	Illegally denormalized fraction: %s
C2545	ERROR	Floating point underflow: %s
C2546	ERROR	-M forbidden when assembler runs on a MIPS machine
C2547	ERROR	-M does not support \\"".extended\\""
C2548	ERROR	-M does not support hex floating point
C2549	ERROR	Floating point literal too long
C2550	ERROR	Too many float literals — compile with \\""-Wb,-nopool\\""
C2551	ERROR	Cannot label a pseudo-op in text section
C2552	ERROR	Shift amount not 0..31
C2553	ERROR	Shift amount not 0..63
C2554	ERROR	gp-relative segments together exceed 64k bytes: %d bytes
C2558	ERROR	MIPS16 move must use a MIPSII gp register
C2559	ERROR	MIPS16 addiu immediate limited to 15 bits
C2560	ERROR	Doubleword opcode not supported by mips2 or earlier
C2575	ERROR	MIPS16 load with symbolic offset must use different base & dest
C2576	ERROR	MIPS16 store may not use symbolic offset in base-offset mode
C2577	ERROR	Non-MIPS16 instruction used in MIPS16 text section
C2578	ERROR	MIPS16 instruction used in non-MIPS16 text section
C2579	ERROR	2nd register invalid in MIPS16 dsrl and dsra
C2580	ERROR	Branch offset not specified
C2581	ERROR	Relative offset not multiple of 4
C2582	ERROR	Relative offset beyond 32768
C2583	ERROR	cprestore offset must be positive and divisible by 4
C2584	ERROR	.cpalias requires a register argument
C2585	ERROR	Number out of range: %s
C2586	ERROR	MIPS16 general purpose register expected
C2587	ERROR	2-register MIPS16 jalr must take $ra as first operand
C2602	ERROR	Assembler op/directive expected
C2603	ERROR	Undefined symbol in expression
C2604	ERROR	Invalid symbol in expression: %s
C2605	ERROR	Symbol must have absolute value: %s
C2607	ERROR	No such label
C2608	ERROR	Too many local labels
C2609	ERROR	Overflow

Share via

MIPS Error Messages C2526 - C2610 (Windows Embedded CE 6.0)

See Also

Reference

Other Resources

Additional resources